Reliable T3 - Manual (Page 10)

10
1. Attach the carpet glide to the floor head. [15]
2. Plug the steam cleaner into the main power. The blue ON light will illuminate
3. After a few seconds the green Steam Ready light will illuminate indicating the
cleaner is ready for use.
4. Recline the cleaner by placing a foot on the floor head and lowering the main
body towards the floor. [9]
5. To produce steam press the steam release button. [10]
6. Move the cleaner slowly backwards and forwards paying particular attention
to high traffic areas. [11]
MAINTENANCE
IMPORTANT: always ensure the cleaner has fully cooled down before performing
any maintenance tasks.
EMPTY THE wATER TANk
1. Unplug the cleaner from the main power and ensure the unit has cooled.
2. Remove the clean water tank for the main body of the cleaner. [5]
3. Twist the cap anti-clockwise and remove. [6]
4. Empty any excess water from the tank. [16] Replace the cap and return to
the cleaner
REMOVING AND CLEANING THE MICRO FIBER PAD
1. Unplug the cleaner from the main power and ensure the unit has cooled.
2. If necessary remove the carpet glider, then peel the textile pad from the floor
base. [17]
3. Wash the textile pad in a washing machine with a mild detergent at max
temperature 40°c.
IMPORTANT: Do not use bleach or fabric softener when washing the textile pad.
REPLACING THE ANTI-SCALE CARTRIDGE
The cleaner is fitted with a hard water filter. If you live in an area of hard water the
filter will discolour over time. Depending on the water hardness and frequency of
use the filter should be changed every 6 months.
1. Unplug the cleaner from the main power and ensure the unit has cooled.
2. Remove the clean water tank for the main body of the cleaner. [5]
3. Lift the hard water filter out of the cleaner. [18] Replace with new filter.
4. Reassemble the clean water tank to your cleaner.