Install the lens mount, Olpf frame installation instructions – RED OLPF FRAME User Manual

Page 8

8 955-0011, Rev-A1

OLPF FRAME INSTALLATION INSTRUCTIONS

InsTall The lens mounT

Make sure it is seated correctly

TIghTen The sCrews

Using a T-20 Torx Driver, seat the four Torx screws

very lightly until finger-tight.

After all four screws are seated; progressively tighten

them in an “X” pattern as shown until hand tight.

IMPORTANT: Tighten the screws snug but do not

over tighten. Torque the screws to 22 in-lbs if using a

torque driver.

InsTall The lens mounT