Ram Trucks 2010 3500 - Owner Manual - Manual (Page 536)

axles. The fluid level should be 5/8 in (16 mm) below the
fill hole on 9 1/4 in manufacturer’s rear axles.
For all 2500/3500 Model axles, the fluid level should be
1/4” ± 1/4 in (6.4 mm ± 6.4 mm) below the fill hole on
the 9.25 in front and 3/4 in ± 1/4 in (19 mm ± 6.4 mm) on
10.5 in rear axles. The 11.5 in rear axle level should be
1/4 in ± 1/4 in (6.4 mm ± 6.4 mm) below the fill hole.
Drain and Refill
Refer to “Maintenance Schedule” for further information.
Lubricant Selection
Refer to “Fluids, Lubricants, and Genuine Parts” in
“Maintaining Your Vehicle” for further information.
NOTE: The presence of water in the gear lubricant will
result in corrosion and possible failure of differential
components. Operation of the vehicle in water, as may be
encountered in some off-highway types of service, will
require draining and refilling the axle to avoid damage.
Limited-Slip Differentials This vehicle requires that
4 oz. (118 ml) MOPAR ௡ Limited Slip Additive or equiva-
lent be added to the gear lubricant. Refer to “Fluids,
Lubricants, and Genuine Parts” in “Maintaining Your
Vehicle” for further information. The MOPAR
௡ Limited
Slip Additive or equivalent should be added to the gear
lubricant whenever a fluid change is made.
2500/3500 Model Axles DO NOT REQUIRE any limited
slip oil additive (friction modifiers).
Transfer Case
Drain and Refill
Refer to “Maintenance Schedule” for further information.
Lubricant Selection
Refer to “Fluids, Lubricants, and Genuine Parts” in
“Maintaining Your Vehicle” for further information.
534 MAINTAINING YOUR VEHICLE