Ram Trucks 2009 1500 - Owner Manual - Manual (Page 113)

Three-Way Calling
To initiate three-way calling, press the VOICE RECOG-
NITION button while a call is in progress, and make a
second phone call, as described under
ЉMaking a Second
Call While Current Call is in Progress. Љ After the second
call has established, press and hold the PHONE button
until you hear a double beep, indicating that the two calls
have been joined into one conference call.
Call Termination
To end a call in progress, momentarily press the PHONE
button. Only the active call(s) will be terminated and if
there is a call on hold, it will become the new active call.
If the active call is terminated by the far end, a call on
hold may not become active automatically. This is cell
phone-dependent. To bring the call back from hold, press
and hold the PHONE button until you hear a single beep.
Redial
• Press the PHONE button to begin.
• After the ЉReadyЉ prompt and the following beep, say
ЉRedial.Љ
• The uconnect௡ phone will call the last number that
was dialed from your cellular phone.
NOTE: This may not be the last number dialed from the
uconnect ௡ phone.
Call Continuation
Call continuation is the progression of a phone call on the
uconnect
௡ phone after the vehicle ignition key has been
switched to OFF. Call continuation functionality avail-
able on the vehicle can be any one of three types:
• After the ignition key is switched to OFF, a call can
continue on the uconnect
௡ phone either until the call
ends, or until the vehicle battery condition dictates
cessation of the call on the uconnect
௡ phone and
transfer of the call to the cellular phone.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 111