Quick Charge Multi Bank - Manual (Page 2)

QUICK START INSTRUCTIONS:
Check that the temporary paper label on the charger marked with
the profile setting matches your battery type. If not, see the
reprogramming section.
If your charger has an ON/OFF switch move it to the OFF
position.
Connect the red charge leads to battery positive, black’s to
negative. But before, make sure the battery is of the same voltage
rating of the charger. If you are unsure, count the number of cells
on each battery and multiply by two. This figure should be the
same as the DC voltage rating of the charger. (see ratings label on
charger)
Charging a battery with a lower voltage rating than the
charger will cause damage to batteries, charger, and can create an
explosive atmosphere.
Plug the charger into AC power and if so equipped, switch the
power switch to the ON position. the LED will flash red for a few
seconds, then turn steady red. When the cycle is 80% complete it
will turn yellow, and finally green when cycle is complete.
If the profile is set to maintain the battery(s), the LED will flicker
green. If the profile is set to shut off, the cycle will end with a
steady green. The LED may also flicker when it is at the high limit
of the charge cycle.
To discontinue charging, move the power switch OFF if equipped,
or unplug AC power.