PS Engineering PMA8000B Installation Manual - Manual (Page 31)

PS Engineering
PMA8000B Audio Selector Panel and Intercom System
Installation and Operator’s Manual
200-890-0101 Page 3-10 Rev. 4, April 2012
Music Distri-
bution Mode Standard Music
Distribution
Alternate Music
Distribution
Music 1
All Headsets
Music
Source
ICS Mode
All Crew ISO All Crew ISO All Crew ISO
Front Panel
Jack
Crew Crew Copilot* Crew
&
Pass
Crew Copilot*
& Pass
Crew Crew Copilot*
Music 1 Input Crew Crew Copilot* Crew
&
Pass.
Crew Copilot*
& Pass.
Crew
&
Pass.
Crew
&
Pass.
Copilot*&
Pass.
Music 2 Input Pass. Pass. Pass. Pass.
*Pilot has Music 1 option in ISO mode
Table 3-3 Music Distribution
Alternate Music distribution modes are announced at power up, unless the power on announcement has
been defeated by holding the TEL and AUX buttons at the same time for more than two seconds. In that
case, the annunciations will not be played at unit power up.
3.11.4 Music 1 Volume
In general, we recommend adjusting the entertainment volume at the source, and only using this as a
master gain control. However, the Music 1 PMA8000BT input can be adjusted from the front panel, if
desired, by pressing the combinations of keys listed.
The Music 1 volume can be adjusted from the front panel, if desired, by pressing and holding the Music
Volume (SPR) key.
Press the Music Volume (SPR) for more than one second, a beep tone will be heard, and the music vol-
ume will begin to increase. To decrease the volume, release the Music Volume (SPR) button, and press
and hold again, the beep tone will occur and the volume will decrease. Continue to hold until the desired
level is reached.
Note: Since it is possible to turn the volume completely off, you may need to turn the volume up if you
don’t hear music when you expect to.
It will take about 10 seconds to go from minimum to maximum volume.
3.11.5 Power on announcement
If the Intercom or Music Distribution is changed from the factory default, the configuration will be
played when the unit is powered up. To defeat this announcement, hold the TEL and AUX buttons when
for more than two seconds. The feature can be enabled again using the same sequence.