Pro Boat PRB8100 - Manual (Page 3)

3
Hand Held Starter
Step 1: Fully charge a 7.2V sub-C battery pack and
install it in the starter as shown.
Step 2: Slide the starting wand (which is stored
inside the battery cover) into the end of the starter,
then replace the battery cover.
Operation
Insert the starting wand into the Tiger Drive
and actuate the starting switch until the engine
begins to run.
NOTE: Stop operation immediately
if the engine enters a hydro-locked
condition as serious engine damage
may occur if operation is continued.
Remove the glow plug, invert
the boat and operate starter to
remove raw fuel before resuming
normal operation.
Maintenance
Lube gears with waterproof grease after every 30
hours of use. Check all screws for tightness after
each run.
Additional Tiger Drives can be purchased separately
though your local hobby shop:
SUL687 TIGERDRIVE: Dynamite .26–.32
SUL689 TIGERDRIVE: Dynamite .12–.25