Pro Boat PRB3750 - Manual (Page 9)

9
The ESC in your Formula Fastech 26
Brushless EP is preprogrammed from the
factory. The programming is set for Ni-MH
batteries as shipped with your Formula
Fastech 26.
A programming module (PRB3311) is
available to change the programming of
your speed control. Settings include Ni-MH
or LiPo batteries, cut-off voltage settings,
cutoff type, brake on or off, motor timing
and throttle curve.
Caution: It is imperative that you do not
attempt to use LiPo batteries in the Formula
Fastech 26 Brushless unless it has been
properly programmed or serious damage to
the batteries and electronics may occur.
Note: Do not turn off the transmitter first
or the receiver may pick up stray signals
and run out of control.
Before and at the end of each run, make sure
all screws are tight and the propeller is free
from any entanglement.
Lubricating the flexshaft is vital to the life of
the drivetrain. The lubricant also acts as a
water seal, keeping water from entering the
hull through the stuffing box.
Lubricate the flexshaft, propeller shaft
and all moving parts after every 2–3 hours
of operation.
 1. Use either two crescent wrenches, two
10mm wrenches, or a combination of
either to loosen the collet nut.
Section 9: Speed Control Programming
Section 8: Maintenance
Section 10: Lubricating the Drive Shaft