Pro Boat PRB3650B - Manual (Page 4)

Retrieval Decoy
Charging Warnings
WARNING: Failure to exercise caution while
using this product and comply with the following
warnings could result in product malfunction,
electrical issues, excessive heat, FIRE, and
ultimately injury and property damage.
• Read all safety precautions and literature prior to use
of this product.
• Never leave the battery and charger unattended
during use.
• Never allow children under 14 years of age to charge
battery packs.
• Never attempt to charge damaged batteries.
• Never charge a battery if the cable has been pinched
or shorted.
• Never allow the batteries or charger to come into
contact with moisture at any time.
• Never charge batteries in extremely hot or cold places
(recommended between 50–80°F (10–26°C)) or in
direct sunlight.
• Always use only Ni-MH rechargeable batteries.
This charger cannot charge batteries such as
“heavy duty”, “alkaline battery”, “mercury
battery” or “lithium battery”.
• Always connect to the charger correctly.
• Always disconnect the battery and charger after
charging and let them cool between charges.
• Always inspect the battery before charging.
• Always terminate all processes and contact Horizon
Hobby if the product malfunctions.
• Always make sure you know the specifications of
the battery to be charged or discharged to ensure
it meets the requirements of this charger.
• Always connect the charge cable to the charger
first, then connect the battery to avoid short circuit
between the charge leads. Reverse the sequence
when disconnecting.
• Always constantly monitor the temperature
of the battery pack while charging.
• Always end the charging process if the charger
or battery becomes hot to the touch or starts
to change form during the charge process.
Decoy Battery Pack Installation
1. Remove the decoy body and cover from the hull.
2. Adhere loop tape (included) to the battery.
Do not cover the battery warning label.
3. Connect the battery to the ESC (electronic speed
control).
4. Secure the decoy battery on the hook strip in the
decoy.
5. Refer to Getting Started instructions about powering
on your decoy.
Tip: Clean the battery pack before installing hook and
loop tape so the adhesive can stick better.
2 2
3 3
4 4
4
EN
Specifications
Length 13 in (330mm)
Beam 6.5 in (165mm)
Height 7.25 in (184mm)
Transmitter 2.4GHz Pistol
Grip Transmitter
Receiver 2-channel 2.4GHz
Hull Material ABS Plastic
Motor 380 Brushed Motor,
water-cooled
ESC
20 amp Brushed
Battery and Charger
DYN4113 2A
Peak Charger
DYN1455 6-cell 1200mAh
Ni-MH battery
4 AA batteries (sold separately) are
required to operate the transmitter.