Pro Boat PRB3550 - Manual (Page 3)

4 5 4
• Miss Elam Brushless EP RTR
• Pro Boat radio transmitter
• Boat stand
Install 8 fully charged AA alkaline batteries
into the transmitter, following the
instructions provided for your radio system.
Be sure to install the batteries with respect
to proper polarity.
Carefully remove the hatch from the hull.
The Pro Boat water-cooled ESC comes
pre-wired with a Dean's connector.
Use a 6-cell battery pack listed below for
optimum performance.
• PRB3313 7.2V 3600mAh
w/Dean's connector
• PRB3314 7.2V 4200mAh
w/Dean's connector
You may also remove the Tamiya connector
from conventional battery packs and
purchase WSD1303 from
your local hobby shop. Be sure to
solder the connectors to the battery
in the proper polarity.
Pro Boat offers a charge adapter (PRB3312)
to allow you to charge the PRB3313 and
PRB3314 batteries with Dean's connectors
with conventional chargers that use Tamiya
connectors.
Follow the instructions included with your fast
charger to ensure a safe charge.
Attach the hook and loop material to the
batteries and the battery boxes.
Confirm that the switch inside the boat is in
the "OFF" position. Install two fully charged
7.2V Ni-MH battery packs into the hull.
Attach the side stand pieces by interlocking
them into the end pieces as shown. Secure
the interlocking pieces with medium CA or
epoxy. Make certain you allow the adhesive
to fully cure before placing your boat on
the stand.
Contents
Section 2: Installing the Transmitter Batteries
Section 1: Assembling the Boat Stand
Section 3: Installing the 7.2V Ni-MH Battery Packs