Pro Boat PRB3400S - Manual (Page 4)

4
Carefully remove the hatch (scale pilot cockpit) .
Make sure the receiver switch is in the "OFF" position . Install a fully
charged 7 .2V Ni-MH battery pack into the radio box . Follow the
instructions included with your fast charger to ensure a safe charge .
Plug the battery into the female battery connector attached to the
electronic speed controller .
Install 4 AA alkaline batteries into the transmitter, following the
instructions provided for your radio system .
Turn on the transmitter, making sure that all three LEDs illuminate on
the power indicator and that the trim knobs are in the center position .
Turn the transmitter off .
Additional Required Items
You will need to purchase the following to get your boat on the water:
• 4 AA alkaline batteries for the radio transmitter
• 7.2V Ni-MH Battery Pack with Tamiya Connector (DYN1050)
• Prophet Sport II Ni-MH Battery Peak Charger (DYN4077)
Section 1: Installation of the Transmitter Batteries
Section 2: Installation of the 7.2V Ni-MH Battery Pack
Assembled Apache 24 EP RTR •
Pro Boat radio transmitter •
Boat stand •
Contents