beautypg.com

Maintenance and repair, When you are finished – Pro Boat PRB3050B User Manual

Page 9

background image

9

EN

Volere 22

Maintenance and Repair

NOTICE: Some tape and adhesives may damage the

finish on your boat. Always test applications on a non-

visible part (such as the finish under the seat on the front

seat hatch) before applying anything to visible areas of

your boat.

If needed, carefully remove dust from your boat with a

clean, soft brush or a lint-free, soft cloth.

The scale details on this boat are not intended for

manipulation. If needed, apply only small amounts of

thin CA (cyanoacrylate adhesive) to repair plastic scale

features on your boat. CA may discolor.

When parts are not repairable, see the Replacement

Parts List for ordering by item number. For a listing of

all replacement and optional parts, refer to the list at the

end of this manual.

general Maintenance

Before and at the end of each run, make sure that all

screws are tight and that the propeller and rudder turn

freely. Lubricate all moving parts with a light household

oil after each boating session to prevent binding and

corrosion.

CAuTION: Always disconnect the battery from the

ESC before performing maintenance on your boat

or injury could result.

CAuTION: Always replace the driveshaft when it is

damaged or shows visible wear or failure resulting

in injury and/or property damage can occur.

When You are finished

1. Power off the ESC.
2. Disconnect the battery.
3. Power off the transmitter.
4. Remove the battery from

the boat.

Always store the boat open (without

the hatch sealed) or moisture may

allow mold and mildew to grow in

the boat.

3

2

4

lubrication

Lubricating the driveshaft is vital to the life of the

drivetrain. The lubricant also acts as a water seal, keeping

water from entering the hull through the stuffing tube.

1. Only magnets hold the seat on the boat. Remove the

seat from the cockpit by tipping it rearward and lifting

it from the cockpit.

2. Lubricate the stuffing tube through the oil fill port near

the motor coupler. Only a few drops of household

light machine oil are needed. If desired, put a paper

towel under the port to capture stray drops.

1