Pro Boat PRB2950 User Manual
Page 4
Parts Required
Plywood.boat.stand.pieces.(4)
Tools.and.adhesives.needed.for.completion
CA.or.epoxy
m
.1..Attach.the.side.boat.pieces.by.interlocking.
them.into.the.end.pieces.as.shown.
m
.2..Secure.the.interlocking.boat.stand.with.
medium-thick.CA.or.epoxy..Make.certain.you.
allow.the.CA.or.epoxy.to.fully.cure.before.
placing.the.boat.on.the.stand.
Unscrew.the.2.knurled.hatch-mounting.screws.from.
the.rear.of.the.hatch..Lift.the.hatch.from.the.boat.
Parts Required
Turn.fin
3mm.hex.screws.(2)
Tools.and.adhesives.needed.for.completion
3mm.hex.driver
Blue.threadlock
m
.1..Locate.the.included.turn.fin..This.will.be.
attached.to.the.right.sponson..Any.attempt.to.
turn.the.boat.left.may.cause.the.boat.to.flip,.
especially.if.this.is.done.in.a.tight.diameter.and.
at.high.speeds.
m
.2..Place.the.Miss.Elam.on.the.completed.boat.
stand.once.the.glue.has.fully.cured.
m
.3..Locate.the.turn.fin.and.the.included.3mm..
hex.screws.(2).to.secure.the.turn.fin.
m
.4..Carefully.place.a.few.drops.of.blue.threadlock.
on.the.threads.of.all.four.hex.screws..This.will.
help.to.keep.the.screws.secured.to.the.blind.
nuts.within.the.sponson.
m
.5..Carefully.attach.the.turn.fin.onto.the.right.
sponson.as.shown.and.tighten.the.hex.screws.
with.a.3mm.hex.driver.
Tools and Accessories Required
12.AA.batteries
2.5mm.hex.wrench
Receiver Batteries
m
.1..Remove.the.2.5mm.hex.head.screws.that.
secure.the.clear.Lexan.radio.box.cover.
m
.2..Remove.the.receiver.battery.holder.and.install.
4.AA.alkaline.batteries.in.the.battery.holder..
Note.proper.polarity.
m
.3..Wrap.the.battery.holder.in.the.foam.
provided..Secure.the.foam.using.a.rubber..
band..Reinstall.the.battery.holder.into.the..
radio.compartment.
Section 3: Removing the Canopy
Section 4: Installing the Radio System Batteries
Section 1: Building the Boat Stand
Section 2: Attaching the Turn Fin