Pro Boat PRB2900T - Manual (Page 14)

1
Section 7: Troubleshooting Guide
Problem Possible Solution
Engine will not start Check needles and make changes back to factory settings if necessary
Improper needle setting
Out of fuel
Improper fuel
Improper glow plug
Glow igniter not charged
Dead glow plug
Flooded engine
Engine starts, then dies Pressure line blocked or unhooked
Reset needles to baseline setting
Improper needle settings
Engine starts and runs for Bad glow plug
several minutes, then dies Idle speed set too low
Improper needle settings
Overheated engine
Glow plug failed due to lean engine setting
Appendix
Turn.Fin
Fuel.Tank
2.5mm.
Manifold.Bolts
Fuel.Line
Water.Cooling.Line
Exhaust.Manifold
Glow.Plug
Carburetor
Water.Cooled.Head
Water.Cooling.Line
Rudder
Propeller
Rudder.
Boot