Pro Boat PRB2800S User Manual

Page 9

Section 9: Troubleshooting Guide

Problem

Possible Cause

Solution

Engine will not start

• Engine is not primed

• Out of fuel

• Improper fuel

• Improper glow plug

• Glow igniter not charged

• Dead glow plug

• Flooded engine

• Put a few drops of fuel into the carburetor venturi

and restart

• Fill fuel tank

• Use 20% Blue Thunder

• Install proper glow plug

• Charge igniter

• Replace

• Remove glow plug, invert boat and engage the

TigerDrive to remove raw fuel from the engine

Engine starts, then dies

• Pressure line blocked or unhooked

• Reset needles to baseline setting

• Connect or replace fuel line

• See Section 6

Engine starts and runs for several
minutes, then dies

• Bad glow plug

• Idle speed set too low

• Improper needle settings

• Glow plug failed due to lean engine setting

• Replace

• See Section 6

• Richen carburetor settings and replace glow plug