Pro Boat PRB2800 - Manual (Page 14)

1
Problem Solution
Engine will not start Engine is not primed: Put a few drops of fuel into
the carburetor venturi and restart
Out of fuel: fill fuel tank
Improper fuel: use 20% Blue Thunder™
Improper glow plug: install proper glow plug
Glow igniter not charged: charge igniter
Dead glow plug: replace
Flooded engine: remove glow plug, invert boat and
engage the Tiger Drive to remove raw fuel from the
engine
Engine starts, then dies Pressure line blocked or unhooked: connect or
replace fuel line
Reset needles to baseline setting: see Section 9
Engine starts and runs for several minutes, then dies Bad glow plug: replace
Idle speed set too low: see Section 9
Improper needle settings: see Section 9
Glow plug failed due to lean engine setting: richen
carburetor settings and replace glow plug
Section 10: Troubleshooting Guide