Section 1: building the boat stand, Section 2: rudder installation – Pro Boat PRB2750 User Manual

Page 5

Section 1: Building the Boat Stand



1. There are 4 plywood pieces. The 2 short

plywood pieces are the ends of the boat stand.



2. Attach the 2 long plywood pieces of the

interlocking boat stand to one end of the short
plywood pieces. Repeat with the remaining short
plywood pieces.



3. Secure the interlocking boat stand with thick

CA or Epoxy.

Parts Needed

Rudder and 2.5mm hex screw



1. Locate the stainless steel rudder and 2.5mm

hex screw.



2. Carefully insert the rudder as shown.



3. Find the flat spot on the rudder. Using a

2.5mm hex wrench, tighten the hex screw on
the flat spot as shown.

Section 2: Rudder Installation