Pro Boat PRB2550 - Manual (Page 10)

10
Use only Zenoah ® 2-Cycle Synthetic Oil and
gasoline mixed 32:1 to power the Miss LLumar.
Keep the fuel in a moisture-free environment,
as stale fuel will cause the Zenoah G26M engine to
lose performance.
Parts Needed
Unleaded gasoline
Zenoah® 2-stroke oil
 1. Mix gasoline and 2-stroke oil (ZEN20001) at a
mixing ratio of 32:1 (gas to oil).
 2. Remove the fuel tank cap and fill the fuel tank
with the gasoline and oil mixture. Use a funnel
to prevent spills. If you do spill, be certain to
immediately wipe it up with a clean towel.
Important
Range check your radio system before the first run
of the Miss LLumar to make certain it is functioning
correctly. Make sure that the receiver antenna is
extended properly.
 1. With the boat in its stand, the radio system
turned on and the transmitter antenna down,
walk off 30 paces (90 feet) from the Pro Boat
™
Miss LLumar.
 2. Have an assistant remain with the boat
to check for proper control movement
from your transmitter input. When you are
satisfied that the radio is functioning properly,
you can continue.
Note: Always perform a range
check prior to operating your boat
after any major repair, installation of
new batteries or at the beginning of
each boating session.
 3. With your assistant again 90 feet away, re-
start the engine. Quickly repeat the same range
check as above, carefully making sure you
observe proper control movement from your
transmitter input. Make certain you complete
this within 60 seconds to prevent the engine
from overheating. Push the kill switch to stop
the engine. Once you are satisfied your radio
system has passed the range check, you are
ready to start the engine and launch your boat.
Section 7: Fueling the Tank
Section 9: Range Check the XR3i Radio System
Section 8: Fuel/Oil Mixture