Pro Boat PRB2350 - Manual (Page 11)

11
Problem Possible Solution
Engine will not start Improper needle setting: see Zenoah Engine Manual; baseline set-
tings are 2 turns out for high-speed, 1 turn out for low-speed
Out of fuel: fill fuel tank
Improper fuel: use fresh Gasoline & Zenoah or Evolution 2-Cycle Oil
(mixed 32 parts gas to 1 part oil)
Bad Spark plug: replace
Flooded engine: remove spark plug, invert boat and operate the pull-
starter to remove fuel
Engine starts, then dies Fuel line blocked or broken: connect or replace fuel line
Reset needles to baseline setting: see Zenoah instructions
Engine starts and runs for Bad fuel: replace
several minutes, then dies Improper needle settings: see Zenoah Engine Manual
Overheated engine: check for clogged or damaged cooling system
Debris in carburetor or filter clunk; disassemble and clean
The hull of the HyperSport™ 48 is finished
using the highest quality paints and the
most advanced painting methods available.
The base coat/clear coat technique delivers
an amazing shine that is as durable as it is
beautiful. To keep your HyperSport 48 looking
new, you should apply a wax coating as used
on automotive finishes to prevent oxidation
and to further protect against damage caused
by fuel and other harmful chemicals.
Section 12: Troubleshooting Guide
Section 13: Hull Care