Pivotal Powersports Quick Connect Terminal User Manual

Pivotal Powersports For motorcycles

Quick Connector Installation Guide

To install our LED Light pods using our Quick

Connector terminals, please follow these

instructions.

After connecting the power wire to the battery, fuse

holder and switch and/ or optional remote, lift all

the orange securing levers on Quick Connect

terminals. When the securing lever is in the up

position, it allows you to insert the wire into the

terminal. When the securing lever is in the down

position, it locks the wiring into the terminal.

Strip each wire that will be connected to the

terminal back 10mm. Run the negative power wire

into one terminal, and run the positive wire into the

another terminal. Use two separate Quick Connect

terminals for installation, one for all the negative (-)

wires, and a separate one for all the positive (+)

wires (Never combine both negative and positive

wires in the same Quick Connect terminal, this will

result in damage to your LED Lighting Kit and/ or

vehicle).

Continue filling each terminal with the appropriate

wires until all lights are connected. Secure the Quick

Connect terminals to the vehicle using double sided

tape or zip ties, making sure to mount them away

from any high temperature objects like an exhaust.

Remember, it is ok to have multiple wires connected

and secured by one lever, but try to spread out the

wiring evenly through the securing levers of the

Quick Connect terminal.

Note: For those individuals that are not technically inclined, we would strongly
recommend that you bring your vehicle to your local mechanic or installer and

have them install the part or parts for you. Pivotal Powersports Corp. is not
responsible for the installation of any of our products.

If you have any additional questions, please contact

us at

[email protected]

Thanks!