Philips QG3280-41 - Manual (Page 6)

O Put the trimmer on the Groomer handle
(fig. 5). You will hear a ‘click’.
B Slide the body trimming comb into the
guiding grooves on both sides of the handle
(fig. 6). You will hear a ‘click’.
B
Press the Hair Length Setting Selector (I)
and slide it to the desired setting (2) (fig. 7).
See Table I for settings.
□ The setting selected will appear on the back
of the Groomer.
> If you are trimming for the first time, start
by using the comb at the maximum trim­
ming length setting (7/16 in/1 I mm) to prevent
accidentally trimming hairs too short. As you
become familiar with the settings, adjust Hair
Length Setting Selector to desired trimming
length. Selector will ‘click’ into position at each
setting.
Body Trimming with Body Trimming
Comb
Table 1. Body Trimming
Remaining hair length
(mm)
Remaining hair length
(in.)
3mm 1/8 in
5mm 3/16 in
7mm 9/32 in
9mm 3/8 in
11 mm 7/16 in
H Switch the Groomer ON (fig. 8).
□ To trim the most effective way, move the
Groomer slowly against the direction of hair
growth (fig. 9). Make sure the surface of the
comb always stays in contact with the skin.
NOTE: Since all hairs do not grow in the same
direction, you may want to try different trimming
directions fi.e.. upwards, downwards, or acrossl.
Practice is best for optimum results.
> If a lot of hair has accumulated in the comb,
remove the comb and blow and/or shake the
hair out of the comb. You can also use the
cleaning brush provided to remove hair from
the comb area.
I REMEMBER:You must reset the hair length
setting selector back to your desired setting
every time you replace the comb on the
appliance.
I The remaining hair length corresponds with
the smallest distance between the cutting blade
and the spot where the comb is in contact
with the skin.
I If you are trimming sensitive areas, always use
the Groomer with the body trimming comb.
B
Turn off Groomer (fig. 10). Rinse the comb
clean after each use.