Philips QG3280-41 - Manual (Page 12)

During Use:
I If cut hairs have accumulated in the comb
area, remove hairs by shaking, blowing or using
cleaning brush provided. Remember to adjust
the trimming length back to your selected set­
ting when you replace the comb on Groomer.
After Each Use:
n Make sure the Groomer is switched OFF
and disconnected from the electrical outlet.
u
Remove any comb or attachment.
D Blow and/or shake out any hair that may
have accumulated in the comb or attachment.
□ Rinse combs, attachments and appliance
under warm tap water or with the supplied
cleaning brush.
B Shake excess water from combs and
attachments and allow to dry thoroughly.
□ Place the attachment back on the Groomer
handle.
Cleaning the Mini Shaver
n Separate the top part of the mini shaver
from its body (fig. 31).
B Blow and/or shake out any hair that may
have accumulated inside the mini shaver
(fig. 32).
B Clean the top part of the mini shaver under
warm tap water (fig. 33) or with the cleaning
brush.
I The shaving foil is very delicate and should not
be handled.
I If foil becomes damaged, do not continue using
the mini shaver. Do not apply pressure to
shaving foil.
I Do not clean the foil with the supplied brush,
as this may cause damage.
D Shake excess water from mini shaver and
allow to dry thoroughly.
Do not use a towel to dry the mini shaver as
damage to the shaving foil could occur.
Cleaning the Body Shaver
D
Pull the shaving foil out of the body shaver
(fig. 34).
B
Blow and/or shake out any hair that may
have accumulated inside the body shaver.
B
Clean the body shaver and shaving foil
under warm tap water.
I The shaving foil is very delicate and should not
be handled.
I If foil becomes damaged, do not continue
using the body shaver. Do not apply pressure
to shaving foil.
► Do not clean the foil with the supplied brush,
as this may cause damage.
□ Shake excess water from body shaver and
shaving foil and allow to dry thoroughly.
Do not use a towel to dry the shaving foil as
damage could occur