Philips HP6512-50 - Manual (Page 6)

Epilating
I For the areas where the hairs are thinner,
hard-to-reach places and areas with bones
close to the skin’s surface (such as knees and
ankles), select speed I (normal speed).
I For larger surfaces and thicker hair areas,
select speed II (high speed).
H Hold the Epilator perpendicular to your leg
at a 90° degree angle with the ON/OFF Slide
Switch pointing in the direction you are going
to move the appliance (Fig. 4).
H Keep the skin taut using your fingers to
stretch the skin so the rotating discs can
grasp the raised hairs (Fig. 5).
Q Gently press and move the Epilator slowly
over the skin against the direction of hair
growth. If you press too lightly or too
hard, the Epilator will not be able to grasp
and remove the hairs. Experiment until
you find the right settings and right amount
of pressure for your type of skin and hair.
Q To switch the Epilator OFF, slide the
ON/OFF Switch to the “O” position.
□ Clean Epilator head after each use.
NOTE: If you choose to use a cream or
moisturizing lotion after use, be certain it
does not contain alcohol as it may cause
discomfort.
IMPORTANT:
► After using the Epilator, some redness or
irritation may occur.This is normal and should
disappear quickly.
I This appliance is only intended for
removing hair below the neck:
underarms, bikini area and legs. Do not
use it for any other purpose.
I Clean the appliance after each use following
CLEANING instructions.