Crosley Radio Memory Master CR2401A - Manual (Page 8)

Playing a Cassette
Accessory: ADAPTER FOR 45 RPM
To Fast Forward or Rewind
Radio Operation
7 8
USB Operation
Basic Operation
Using the included software and cable, the USB
connection allows you record your records onto your
computer. Follow these instructions to use the USB.
1 Insert the enclosed software CD into your
computer.
2 Follow the instructions on the computer screen
to install the software. If the software does not
load automatically, browse the CD and open
the Read Me folder for further instructions.
3 Connect the small end of the USB cable to the
USB JACK (41) on the back of the unit.
4 Connect the other end to a USB port on your
computer.
5 On your computer, open the Record Recording
Software.
6 For instructions on operating the Record
Recording Software, browse the software CD
and open the Read Me folder.
Antenna
Antenna: for FM reception, the unit is provided with
a FM WIRE ANTENNA (38) , move the wire until
the reception is clear and with no interferences. For
AM reception, the unit is provided with a directional
build-in ferrite antenna. Rotate the set to find the
position in which the best reception is obtained. Do
not connect the EXTERNAL FM ANTENNA (38) to
any outside antenna.
1
Make sure the unit is plugged in correctly to an
AC outlet.
2
Press the POWER button (17/43) to turn on the
unit .
3
Once the power is turned on, press the
FUNCTION button (2/66) to switch between
CD/Tuner/Phono/Aux. When switching between
functions, wait one second after pressing the
function button before pressing it again. This
gives the unit time to load the correct information
for the selected function.
1
Press the FUNCTION button (2/66) to set the
unit to Tuner mode
2
Press the BAND button (4/56) to select the
desired tuning band (AM/FM).
3
Select the desired radio station by rotating
Tuning knob (24).
4
Adjust the volume to the desired listening level.
Turntable Operation
1
Press the FUNCTION button (2/66) to set the
unit to Phono mode.
2
Set the SPEED CONTROL SWITCH (34) to
the correct speed (331/3, 45 or 78 rpm) for the
selected record.
3
Use the CUE LEVER (32) to raise the tone arm
off its rest. Move the tone arm over the record
and use the cue lever to lower it to the point
you want the record to start.
4
At the end of the record, the tone arm will return
to its rest.
NOTE:The turntable and cassette players both operate
in the same mode. Make sure the cassette
player is in STOP mode when listening to a
record.
To play the 45rpm record, place the ADAPTER (42)
on the spindle.
General
1
While in Phono mode,press the STOP/EJECT(28)
button on the cassette player to open the cassette
door.
2
Insert a prerecorded cassette tape into the
cassette door.
3
Press the PLAY button (25) to begin play.
4
To stop playback, press the STOP/EJECT (28)
button.
5
Press the STOP/EJECT (28) button again to
eject the cassette.
1
While playback is stopped, press the FAST
FORWARD (27) or REWIND (26) button to fast
forward or rewind the cassette.
2
Once the desired position is reached on the
cassette, press the STOP/EJECT (28) button
to stop the cassette.
3
Press the PLAY (25) button to begin play.
NOTE: The cassette player plays the side of the
cassette facing away from the unit. To
play the other side of the cassette, you
must eject the cassette and turn it over.
Basic Operation