Crosley Radio Memory Master CR2401A - Manual (Page 6)

Erasing a CD-RW
12
If using a CD-RW, you can erase the whole CD and
rerecord it. Erase procedures are only possible with
CD-RW discs. It is not possible to erase or rerecord
a CD-R CD. To erase a CD-RW, follow the steps
below.
1
Press the FUNCTION button (2/66)
to set the unit to CD mode.
2
Load a recorded CD-RW into the unit.
3
Press the STOP button (18/51) to stop playback.
4
Press the ERASE button (9/55). ERASE will
appear on the display ,Press PLAY Button(19/61)
to confirm and the erasing process will begin.
When finished, the display will first read “F Done”
and then “BLANK”.
5
The CD is now ready to record.
NOTE: Once a CD is erased, the contents that were
on the CD cannot be retrieved.
The Recording level should normally be set in
the middle position during recording. If the record
being recorded plays too loud or too soft,
you can adjust the recording level by turning the
Record Level knob (11). To increase the recorded
volume, turn the Record Level knob (11) clockwise
to the desired position. To decrease the recorded
volume, turn the knob counter-clockwise.
Table of Contents
About This Manual
Thank you for purchasing the Crosley Memory Master
(CR2401A). Before operating this unit, please read
this manual thoroughly and retain it for future
reference.
Instructions in this manual describe the control
functions of the CR2401A.
Included in the package:
Welcome
Memory Master
Remote Control
45 RPM adaptor
RCA to 3.5mm Stereo cable
USB cable
Software disc
Software Installation Guide
Getting Started
Unpacking................................. 4
Power Source........................... 4
Control Locators.......................
5-6
Basic Operation
General..................................... 7
Radio Operation....................... 7
USB Operation....................... 7
Turntable Operation.................. 8
Cassette Operation..................
8
CD Operation
Playing a CD............................ 9
Programmed Playback............. 9
Playing MP3 CD’s................... 10
Recording records to CD........ 11
Recording cassettes to CD..... 11
Erasing CD-RW CD’s.............. 12
Audio / Connections
Audio......................................... 13
General
Troubleshooting Guide............. 14
Warranty.................................... 15
CD Operation
Recording Level
Manual Track Division
You can divide your recording into separate tracks
if you wish. By doing this, each song will have its
own sequential track number. To do this, you must
use the Split Track button (6/54).
While Recording your record or cassette, listen for
the end of each song. There will usually be a brief
silence between songs. Once you are at the end of
the song, press the Split Track button. The recording
will then go to the next track number by increments
of one. Once the recording is finished, you can press
the (20/62) or the (21/50) buttons to go to
the beginning of each song.
Recording level using the Record level knob (11)
1
Play the source to the recorded and adjust the
recording level so that the loudest or small sound.
NOTE: Record level knob normal set to centre position.