Philips QT4010-40 - Manual (Page 6)

Cleaning
I
Clean the Trimmer after each use.
I Do not use water or a moist cloth to clean the
Trimmer.
I Always switch Trimmer OFF, unplug and remove
power supply cord from Trimmer before clean­
ing.
I
Do not use compressed air, abrasive cleaning
agents, scourers or liquids such as alcohol,
benzene, bleach or acetone to clean the
Trimmer and attachments.
I Never clean, replace or remove Trimmer
attachments with motor ON.
I
Do not apply pressure to cutters.
I Do not touch cutters with hard objects as this
may damage them.
I Do not use while bathing, showering or
immerse Trimmer in water or other liquids as
damge to Trimmer may occur.
During Use:
I If cut hairs have accumulated in the comb
area, remove hairs by shaking, blowing or using
cleaning brush provided. Remember to adjust
the trimming length back to your selected set­
ting when you replace the comb on Trimmer.
After Each Use:
I
Make sure the Trimmer is switched OFF
and disconnected from the electrical outlet.
a
Remove the comb from Trimmer.
D Blow and/or shake out any hair that may
have accumulated in the comb.
□ Clean the comb and appliance with the
supplied cleaning brush or a dry, soft cloth.
B Remove beard trimmer attachment from
Trimmer handle.
□ Rinse beard trimmer attachment only
thoroughly under warm tap water (fig. 6).
Never rinse beard trimmer attachment still
attached to Trimmer handle.
I
Shake excess water from attachment and
allow to air dry thoroughly (fig. 7).
B Place the beard trimmer attachment back on
the Trimmer.
This Trimmer has no other user-serviceable parts.
For assistance call 1-800-243-3050.