Philips QT4010-40 - Manual (Page 5)

B Press the Hair Length Setting Selector (1)
and slide it to the desired setting (2) (fig. 4).
See Table 1 for settings.
Table 1. Beard Trimmer
Remaining hair length
(mm)
Remaining hair length
(in.)
2mm 5/64 in
4mm 5/32 in
6mm 1/4 in
8mm 5/16 in
10mm 13/32 in
12mm 15/32 in
14mm 9/16 in
16mm 41/64 in
18mm 23/32 in
> If you are trimming for the first time, start
by using the comb at the maximum trimming
length setting (23/32 in/18mm) to prevent
accidentally trimming hairs too short. As you
become familiar with the settings, adjust Hair
Length Setting Selector to desired trimming
length. Selector will “click” into position at each
setting.
B
Switch the Trimmer ON (fig. 5).
□ To trim in the most effective way, move the
Trimmer against the direction of hair growth.
Make sure the surface of the comb always
stays in contact with the skin.
NOTE: Since all hairs do not grow m the same
direction, you mav want to try different trimming
directions (i.e„ upwards, downwards, or acrossV
Practice is best for optimum results.
► If a lot of hair has accumulated in the comb,
remove the comb and blow and/or shake the
hair out of the comb.You can also use the
cleaning brush provided to remove
hair from the comb area.
I REMEMBER:You must reset the hair length
selector back to your desired setting every time
you replace the comb on the appliance
I The remaining hair length corresponds with
the smallest distance between the cutting
blade and the spot where the comb is in contact
with the skin.
Beard Trimming Without
Beard & Moustache Comb
Remove comb if you are:
I Defining hair lines
I
Trimming nape of neck
I Removing single, unwanted hairs
B Be certain the Trimmer is in the OFF
position.
B
Remove the comb by pressing the Hair
Length Setting Selector (1) and slide the
comb upwards (2). Pull comb offTrimmer.
B Switch the Trimmer ON.
□ Make well-controlled movements. Touch the
hair/skin lightly with the Trimmer.