Coleman 2300 Series - Manual (Page 5)

To Set Up
cont.
• Installation of propane cylinder in Hot Water on Demand TM unit.
• Use standard propane cylinders made for camping products.
• Do not use 14.1oz cylinders normally used for hand torches.
• Do not use MAPP gas cylinders or any other fuel except propane.
• Make sure the control knob is turned “OFF ”.
• Push in on the propane access door latch that is located on the left side of the door and swing door to opened position.
Open the Propane Access Door.
Remove propane cap. Install the propane cylinder.
• Check for Propane Leaks
• Make 2 to 3 oz. of leak check solution (one part liquid dishwashing
detergent and three parts water).
• Apply several drops of solution at the connection between the propane
cylinder and the regulator. (Fig. 2)
• Bubbles indicate a leak.
• Check that the connection is not cross-threaded and that it is tight.
• Perform another leak check. If there is still a leak, remove the cylinder
and contact Coleman for services or repair.
WARNING
• Perform leak test outdoors.
• Extinguish all open flames.
• NEVER leak test when smoking.
• Do not use Hot Water on Demand
TM unit until connection has
been leak tested and does not leak.
5
WARNING
• If using refillable propane cylinder, the LP-gas cylinder(s) must be
constructed and marked in accordance with the specifications for
LP-gas cylinders of the U.S. Department of Transportation or
Transport Canada, CAN/CSA B339. Use only Coleman® acces-
sories or parts. During heater set-up, check all hoses and fittings
for leaks using soapy water. Never use a flame. Always keep refill-
able cylinders outdoors, never inside house, camper or tent.
Fig. 2
• Remove cap from propane cylinder but do not discard.
• While holding the propane cylinder upright, thread it into
the REGULATOR located inside the door by turning as
shown. Be careful not to cross-thread, hand tighten only.