Problem solving & support, Specifications – Philips SHB1300-27 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To adjust the neckband in size:
• Open the clip (S4)
• Move the slider (S5) up or downward on the earplug
cable
• Fix your preferred length with the clip (S4)
For optimal wearing comfort choose one of the three
included rubber ear caps that best fits your ear and place
it on the earplug.
Problem solving & support
Problem
Possible cause
Solution
Bluetooth headset does
not switch on.
Battery is very low.
Charge the battery.
No connection to mobile
phone.
Bluetooth disabled.
Enable Bluetooth on your
mobile phone and turn the
HS on.
Mobile phone cannot find
headset
Headset may not be in
pairing mode. (HS stays in
pairing mode for 4 min.)
Put HS in pairing mode as
described above.
Pairings may have been
reset.
Start the pairing process as
describe above.
Redialing does not work.
Your mobile phone may
not support this feature.
Voice dialing does not
work.
Your mobile phone may not
support this feature.
for additional support.
Specifications
Rechargeable Lithium-Ion battery
Bluetooth 1.2 compliant, HSP, HFP
Range: Up to 33 feet / 10 meters
Typical standby time: 200 hours
Typical talk time: 7 hours
Typical charging time: 3 hours
Design and specifications are subject to change without notice. Talk time and stand-by
time may vary.
Federal Communication Commission
Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (I) this device my not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications made to this equipment not expressly approved by
Philips may void the FCC authorization to operate this equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontr
olled environment. End users must follow the specific operating instructions for satis
fying RF exposure compliance.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Trademarks
The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use
of such marks by Koninklijke Philips Electronics N.V. is under license. Other trademarks
and trade names are those of their respective owners.
8