Cobra Electronics 2010 GTL WX - Manual (Page 16)

14
Section V Maintenance and Adjustment
The COBRA 2010 GTL WX transceiver is specifically designed for the environment
encountered in base station installations. The use of all solid state circuitry and its light
weight result in high reliability. Should a failure occur, however, replace parts only
with identical parts. Do not substitute. Refer to the schematic diagram and parts list.
NOTE
If the performance described in the OPERATION and MAINTENANCE
AND ADJUSTMENT sections is not obtained, review the operating instru-
ctions to insure that proper procedures were followed. If a problem still
exists, refer to WARRANTY SERVICE INSTRUCTIONS elsewhere in
this manual.
FCC WARNING
All transmitter adjustments other than those provided on front panel
by the manufacturer must be made by or under the supervision of the
holder of an FCC-issued general radio-telephone operator’s license.