Cobra Electronics COBRA MARINE MR HH330 FLT EU - Manual (Page 17)

VHF Marine Radio Protocols Operating Your Radio
29 Nothing Comes Close to a Cobra ®
Floating Feature
VHF Marine Radio Protocols Operating Your Radio
28 English
Advanced Operation
Burp Feature
Cobra’s Burp feature allows the operator to expel water from
inside the speaker grill. This is especially useful if the radio is
dropped overboard or during extreme foul weather conditions.
In these conditions, water can become trapped in the
speaker grill and muffle the audio.
To Activate Burp:
1. Press and release the 16 and SCAN keys at the
same time.
2. The Burp tone(s) at maximum level will sound
from the internal speaker for eight seconds.
3. During this time, the LCD will display the following
“burp” as shown to the left.
4. Hold the radio with the speaker grill down to help
the water drain out.
5. Press the ESC key at any time to cancel the
BURP feature.
Floating Radio
This radio is designed to float if dropped overboard. The orange
center makes it visible and easy to retrieve. This rugged radio
is also designed to meet JIS7 (IPX7) specifications. This means
it’s designed to operate properly after being submerged in
one meter deep water for 30 minutes.
NOTE
Do not leave the radio floating in water permanently.
This could cause premature corrosion of the battery
contacts and other damage.
The radio is only designed to float with its included
Lithium-ion battery. Using other approved batteries
might cause the radio to sink. This includes the optional
AA battery tray, depending on the weight of the AA
batteries used.
Burp Feature
Burp Feature
Floating Radio
Memory Location Scan Mode
During Memory Location Scan mode, the radio will rapidly
scan through all pre-assigned memory channels.
NOTE
The radio must be squelched for Memory Location
Scan mode to function. See page 18 for Squelch
procedure.
NOTE
If there are fewer than two (2) memory locations
programmed in the radio, the Memory Location Scan
option will not be available. To program at least two
(2) memory locations, see page 25.
To Enter Memory Location Scan:
1. From Marine Standby mode, press the MEM/ESC
button.
2. Press the SCAN button. The radio will immediately
begin to scan all pre-assigned memory channels.
The SCAN and MEM icons will show on the LCD.
3. A signal on any channel will stop the scan for 10
seconds to allow you to listen to the traffic on that
location.
4. Press the Channel Up/Down button to resume
scanning the Memory Location Scan channels or
to change the scan direction.
5. To EXIT Memory Location Scan mode, press the
SCAN button again. The SCAN and MEM icons will
disappear from the LCD and the radio will return to
Marine Standby mode.
A
A
Memory Location Scan
MEM/ESC Button
SCAN Button
MRHH330EU_MANL_vC.qx:MRHH330_ENG_Body 12/28/09 10:05 AM Page 28