Lighting instructions to turn off gas to appliance – Louisville Tin and Stove DVCF558B-R User Manual
Page 8
LIGHTING INSTRUCTIONS: DVCF403B, DVCF404B, DVCF653B, DVCF654B
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted by
hand. When lighting the pilot, follow these instruc-
tions exactly.
B. BEFORE LIGHTING, smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the
floor.
WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electric switch, do not use any
phone in your building.
•
Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
•
If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or slide the gas control
lever. Never use tools. If the lever will not push in or
slide by hand, don’t try to repair it, call a qualified service
technician. Force or attempted repair may result in a fire
or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been under water.
1.
STOP! Read the information on the safety label.
2.
Set thermostat to lowest setting.
3.
Turn off all electric power to the appliance.
4.
Remove cabinet door.
5.
Push in gas control lever slightly and slide right
$
to “OFF”.
6.
Wait five (5) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas, STOP!
Follow “B” in the information on the safety label. If you
don’t smell gas, go to the next step.
7.
Open sight glass cover.
8.
Locate red piezo ignitor button on side of gas control.
Locate pilot behind sight glass. (Follow metal pilot tube
from gas control).
9.
Slide gas control lever left
%
to “Set” and hold.
Immediately begin a series of pushing and releasing the
red piezo ignitor button, while observing the pilot through
the sight glass. Continue to spark until pilot is lit.
Continue to hold the gas control lever to “Set” for about
one (1) minute after the pilot is lit. Release the gas control
lever and it will return to “Pilot”. Pilot should remain
lit. If pilot goes out, repeat steps 5 thru 9.
•
If gas control lever does not return to “Pilot” when
released, STOP and immediately call your service
technician or gas supplier.
•
If the pilot will not stay lit after several tries, slide the
gas control lever to “OFF” and call your service technician
or gas supplier.
10. Close sight glass cover.
11. Slide gas control lever right
$ to “ON”.
12. Replace cabinet.
13. Turn on all electric to the appliance.
14. Set thermostat to desired setting.
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
1.
Turn thermostat to it’s lowest setting.
2.
Turn off all electric power to the appliance if service is to be performed.
3.
Remove cabinet door.
4.
Push in gas control lever slightly and slide right
$
to “OFF”. Do not force.
5.
Replace cabinet door.
Gas Control
Lever
Max. (High)
Pressure Regulator
Outlet (Manifold)
Pressure T
ap
Step Pressure Regulator
NOTE: Knob
can not be
moved to
“OFF” unless it
is pushed in
slightly. Do
not force.
Page 8