beautypg.com

Pek kit instructions – Louisville Tin and Stove DVCF558B-R User Manual

Page 15

background image

14-PEK KIT INSTRUCTIONS

(14’ PLUG EXTENSION KIT)

FOR NON-RECESSED INSTALLATIONS ONLY

90 Degree
Outside
Corner

3 FT.
SECTION

W

ALL

3 FT.
SECTION

BOTTOM
SECTION

1

2

3

4

UNITS WITH TERMINAL BOARD

STEP #
1. Turn heater off following Section 3 in “Lighting

Instructions” and allow to cool.

2. Turn off all electricity to heater.
3. Remove top louver assembly, fan shroud and fan

blade.

4. Loosen two screws on romex connector.
5. Remove junction box cover plate.
6. Disconnect three power cord terminals and pull

power cord out of top of heater.

7. Insert power cord provided in kit through romex

connector and plug onto terminal board following
wiring diagram found in lighting and operating
instructions.

8. Tighten two screws on romex connector.
9. Replace junction box cover plate.
10. Replace fan blade, fan shroud and top louver

assembly.

11. Snap 90 degree outside corner (Ref. 1) onto 3

foot section (Ref. 2) plastic raceway. Insert power
cord and remove blue backing from adhesive strip
on raceway and apply to side of heater.

12. Insert power cord into second 3-foot section of

raceway (Ref. 3) and remove blue backing and
apply to side of heater, butting up against bottom
of other section.

13. Cut 14-inch long bottom section to required length

(see chart), insert power cord, remove backing
and apply to side of heater.

14. Plug power cord into wall receptacle.
15. Light the heater following lighting instructions.

Page 15

LENGTH OF BOTTOM
SECTION (REF. 4)

MODEL NO.

PLASTIC RACEWAY

DVCF40

5-5/16 Inches

DVCF55

14 Inches

DVCF65

14 Inches

NOTE: Above lengths terminate approximately
2 inches above floor.

This manual is related to the following products: