Cisco 7971G - Manual (Page 3)

3-3
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.0 (SIP), Cisco Unified IP Phones
OL-8182-01
Chapter 3 Setting Up the Cisco Unified IP Phone
Before You Begin
If you plan to use auto-registration, verify that it is enabled and properly
configured in Cisco Unified CallManager before connecting any
Cisco Unified IP Phone to the network. For information about enabling and
configuring auto-registration, refer to Cisco Unified CallManager Administration
Guide. Also, see the
“Adding Phones to the Cisco Unified CallManager
Database” section on page 2-13 .
You must use Cisco Unified CallManager to configure and assign telephony
features to the Cisco Unified IP Phones. See the
“Telephony Features Available
for the Phone” section on page 5-2 for details.
In Cisco Unified CallManager, you can add users to the database and associate
them with specific phones. In this way, users gain access to web pages that allow
them to configure items such as call forwarding, speed dialing, and voice
messaging system options. See the
“Adding Users to Cisco Unified CallManager”
section on page 5-16 for details.
Safety
Review the following warnings before installing the
Cisco Unified IP Phone 7970. To see translations of these warnings, refer to the
Regulatory Compliance and Safety Information for the Cisco Unified IP Phone
7900 Series document that accompanied this device.
Warning Read the installation instructions before you connect the system to its power
source.
Warning Only trained and qualified personnel should be allowed to install, replace, or
service this equipment.
Warning Ultimate disposal of this product should be handled according to all national
laws and regulations.