Chicago Electric 9"Angle Grinder 93179 - Manual (Page 4)

Page 4 For technical questions, please call 1-800-444-3353. SKU 93179
10. Never leave the tool unattended when it is
plugged into an electrical outlet. Turn off the
tool, and unplug it from its electrical outlet before
leaving.
11. use only 9” diameter grinding wheels having
a 5/8” or ( 7/8” if using included arbor adaptor)
center mounting hole. Never disable or modify
the wheel guard.
12. WARNING! Never install a carbide tipped or
steel circular saw blade for use in this tool.
Never install a wood carving blade, carving
disc with chain saw cutters, or a cutting carv-
ing disc on this tool.
13. For safest operation, it is recommended that
only these accessories be used with this tool:
Abrasive cutoff discs and wheels, flap wheels,
wire brushes, wire wheel brushes.
14. WARNING! People with pacemakers should con-
sult their physician(s) before using this product.
Operation of electrical equipment in close proxim-
ity to a heart pacemaker could cause interference
or failure of the pacemaker.
GROuNDING
tO pREVENt
ELEctRIc ShOcK
AND DEAth FROM INcORREct
GROuNDING WIRE
cONNEctION:
Check with a qualified electrician
if you are in doubt as to whether
the outlet is properly grounded.
Do not modify the power cord
plug provided with the tool.
Never remove the grounding
prong from the plug. Do not use
the tool if the power cord or plug
is damaged. If damaged, have it
repaired by a service facility
before use. If the plug will not fit
the outlet, have a proper outlet
installed by a qualified
electrician.
Double Insulated tools: tools with
two prong plugs
Outlets for 2-prong plug
Tools marked “Double Insulated” do not 1.
require grounding. They have a special
double insulation system which satisfies
OSHA requirements and complies with
the applicable standards of Underwriters
Laboratories, Inc., the Canadian
Standard Association, and the National
Electrical Code.
Double insulated tools may be used in 2.
either of the 120 volt outlets shown in the
preceding illustration. (See Outlets for
2-prong plug.)
Extension cords
Grounded 1. tools require a three wire
extension cord. Double Insulated
tools can use either a two or three wire
extension cord.
As the distance from the supply outlet 2.
increases, you must use a heavier gauge
extension cord. Using extension cords
with inadequately sized wire causes a
serious drop in voltage, resulting in loss
of power and possible tool damage.
(See table A.)
The smaller the gauge number of the 3.
wire, the greater the capacity of the cord.
For example, a 14 gauge cord can carry
a higher current than a 16 gauge cord.
(See table A.)