Coleman 8200 Series - Manual (Page 3)

Tools Needed:
Phillips head screwdriver
1/4" nut driver *
9/16" wrench
Adjustable wrench
Fig 4
Fig 1
Fig 2
Fig 3
Rear Heat Shield
Screws
Heat Tents
Screws
* 1/4” socket set with extension can also be used.
Natural Gas Conversion Instructions
Be sure gas supply is off, the knobs are in the off
position and the grill is cool.
1. Remove cooking grates and heat tents (Fig. 1).
2. Remove the screws holding the rear heat
shield in place. Lift out rear heat shield and set
aside (Fig. 2).
3. Remove the two screws holding each electrode in
place (Fig. 3).
4. Lay igniters on floor of grill (Fig. 4).
3