Carrier POSITIVE PRESSURE STORAGE SYSTEM 19XB - Manual (Page 6)

Table 2 — Physical Data
19EA Pumpout Unit
ENGLISH (SI)
Pumpout Unit Weight* lb (kg) 210 (95)
Pumpout Condenser Water Flow Rate gpm (L/s) 5 to 7 (.32 to .44)
Pumpout Condenser Water Pressure Drop psig (kPa) 6 to 10.7 (41.4 to 73.8)
Maximum Entering Condenser Water Temperature F (C) 85 (29)
Maximum Leaving Condenser Water Temperature F (C) 100 (37)
Condenser Relief Valve (Fusible Plug) psig (kPa) 385 (2655)
Condenser Pressure Rating
Refrigerant Side psig (kPa) 385 (2655)
Waterside psig (kPa) 150 (1034)
Compressor Rating 1750 rpm (29 r/s) Reciprocating cfm (L/s) 8.7 (.25)
Valves (4-Valve Manifold, Copper with
Brass Turn Knob Valves)
in. OD 1 ⁄ 2 1 ⁄ 2
*The pumpout unit weight includes the compressor/condenser, control box, and the oil separator.
NOTES:
1. The motor is hermetic with thermal protection.
2. The control box is mounted and wired with a fuse on/off switch according to NEMA 1 (National
Electrical Manufacturing Association).
3. The starter contactor is located in the control box. The overloads on the motor are wired and the
disconnect switch is supplied by the customer.
4. The condenser tube is copper.
Fig. 4 — Rigging Guide
STORAGE
TANK SIZE
CENTER OF GRAVITY
APPROX. DIM. — ft-in. (mm)
EMPTY WEIGHT
LB (Kg)
A B
28 Ft 3
4- 5 1 ⁄ 4
(1353)
1-7 7 ⁄ 8
(505)
2380
(1080)
52 Ft 3
6-10 1 ⁄
8
(2086)
1-8 3 ⁄
4
(527)
3460
(1569)
NOTES:
1. Each chain must be capable of supporting the entire weight of the
machine.
2. Minimum chain length:
28 ft 3 tank — 10 Ј -0 Љ
52 ft 3 tank — 15 Ј -6 Љ
3. Total weight equals empty weight from chart and charge weight
given on label.
6