Troubleshooting, Warning, Problem possible cause solution – Philips AZ1209-17 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLESHOOTING
WARNING
If a fault occurs, first check the points listed
below before taking the set for repair.
Under no circumstance should you try to
repair the set yourself as this will
invalidate the guarantee.
If you are unable to solve a problem by
following these hints, consult your dealer or
service center.
Problem
Possible cause
Solution
No sound.
VOLUME is not adjusted.
Adjust volume.
no power
Headphone is connected.
Disconnect headphone.
Mains cabie is not securely connected.
Connect mains cable properly.
Batteries are flat.
Insert fresh batteries.
Batteries are inserted incorrectly.
Insert batteries correctly.
Trying to change over from mains to
battery suppiy without removing the plug.
Remove the mains plug from the
unit's AC MAINS inlet.
No
reaction
to
Electrostatic discharge,
operation of any keys
Disconnect the set from power supply,
reconnect after a few seconds.
Poor radio reception
Weak radio signal.
Direct the antenna for optimum
reception.
Interference caused by vicinity of eiectrical
Keep the radio away from electrical
equipment like TVs, computers, engines, etc..
equipment.
no d ibi
or
The CD is badly scratched or dirty.
Replace or clean the CD.
Cd Srr
indication
No CD is inserted.
Insert a CD.
The CD is inserted upside down.
Insert CD with label upwards.
The iaser lens is steamed up.
Wait until the lens has cleared.
The CD skips tracks
The CD is damaged or dirty.
Replace or clean the CD.
SHUFFiE or ptroGtiAH is active.
Switch off SHUFFIE or PROGrrAM play.
Poor cassette
Dust and dirt on the heads, capstans or
Clean heads, capstans, and pressure
sound quality
pressure roliers.
rollers.
Use of uRsuitable cassette types
Only use NORMAL type cassettes for
(METAL or CHROME) for recording.
recording.
Recording does
not work
Cassette tab(s) may be snapped off.
Apply a piece of adhesive tape over
the aperture.
Remote control does
Batteries are inserted incorrectly.
Insert batteries correctly.
not function properly
Batteries are flat.
Insert fresh batteries.
Distance to the set is too large.
Reduce distance.
15