Osprey PORTER 30 - Manual (Page 4)

PORTER SERIES
OWNERS MANUAL
3
PACK ATTACHMENT
The sliders along the sides of the Daylite button through
the four cord loops found on the Porter’s front panel. Push
the slider through the cord loop from underneath and
tug on the straps to tighten. Adjusting the tension on the
straps will allow you to stash additional gear behind the
Daylite.
ERGOPULL™ HIPBELT
The stow away nylon hipbelt with fabric hipwings utilizes
Osprey’s exclusive modifi ed straight ErgoPull™ closure.
To operate, loosen the webbing enough so that you can
connect the center buckle. Grasp the loose ends of the
webbing on either side and pull in and across evenly with
both hands at the same time.
LOCKABLE PANEL LOAD ACCESS
A dual lockable zippered front panel provides access
to the main compartment. Once inside, the internal
organization consists of one internal mesh zippered
pocket, one internal fabric zippered pocket and ample
space for additional gear.
STRAIGHTJACKET™ COMPRESSION
Dual foam padded sidewalls work in conjunction with our
StraightJacket™ compression system to both protect
contents and stabilize loads. Loads can be compressed
and stabilized by tensioning the dual StraightJacket™
straps on the pack’s front panel When contents are less
than full the protected buckles on the right side panel
of the pack serve as connection points for the straps
compressing and stabilizing your load.
FRONT PANEL ORGANIZATION COMPARTMENT
A lockable zippered front panel organization
compartment provides additional organization and
easily accessible storage capabilities. Once inside the
compartment you will fi nd a padded laptop sleeve, a
zippered, padded tablet sleeve, organizational pockets
and ample room for extra gear.
STOWABLE HARNESS AND HIPBELT
A zippered compartment on the Porter’s backpanel
provides access to a stow away padded shoulder
harness and nylon hipbelt with foam padded hipwings
for use during backpack style carry.
1 Remove the shoulder harness from the top
zippered compartment on the backpanel and the
hipbelt from the fabric compartment at the base
of the backpanel.
2 Connect the male buckle found on the nylon
harness tensioning straps to the female buckle on
the hipbelt’s fabric hipwings and tension to fi t on
body. Reverse this process to once again stow the
harness and hipbelt.
PORTER SERIES SHARED FEATURES / DETAILS