Stand-alone mode, Master/slave mode – OmniSistem PR XS 250 User Manual

Page 7

Text mode
Original mode

7/22

been enabled.
Press button FUNC, it will return to the upper menu one by one.

STAND-ALONE MODE

Operate the projector without connecting a controller, enable the master mode in the operation panel, the
projector will run in Stand-Alone mode automatically.

MASTER/SLAVE MODE

Without using a controller, many projectors can run synchronously in the Master/Slave mode by linking them
with each other. Select one projector as the master with setting options master mode enabled but slaves.
Regard the other projectors as the slaves with setting options slave mode enabled and all DMX start
address “001”.

Connect the controller’s output to the first fixture’s input, and connect the first fixture’s output to the second fixture’s input
and connect the rest fixtures in the same way. Eventually connect the last fixture’s output to a DMX terminator as shown
in the figure below.