Craftsman 137.21807 - Manual (Page 32)

32 33 32 33
If the blade is partial to left side:
1. Turn the right adjustment screw (3)
counterclockwise and adjust the left
side adjustment screw (2) clockwise.
2. Remeasure, as described in steps 4
to 9 in the prior section.
3. When alignment is achieved, turn
the right adjustment screw (3) until it
touches the pivot rod (4).
Fig. KK
THE LASER LINE
This tool is equipped with the Laser
Trac
R , which is a battery-powered
laser cutting guide. The laser line
allows the operator to anticipate the
path of the saw blade on the workpiece
before cutting begins.
The laser beam is emitted when the
laser line is turned on. Do not stare
into the beam or view it directly
using optical instruments. Do not
remove the warning label that is
affixed to the blade guard. Avoid
aiming the laser beam directly into
the eyes.
● A laser beam is not a toy, and it
should not be used by children.
Misuse of this laser line can lead to
irreparable eye damage.
● Do not perform any adjustments
that are intended to increase the
power of the laser.
● When using the laser line, do not
point the laser beam at people and/
or reflecting surfaces. Even a low-
intensity laser beam can cause eye
damage. Do not look directly into
the laser beam.
● If the Laser Line will not be used for
more than three months, remove
the batteries in order to avoid
damage from possible leakage.
● The laser line does not include any
user-serviceable components. Do
not open the housing in an attempt
to repair it.
● Repairs should only be carried out at
a service center or by an authorized
service technician.
● NOTE: All the adjustments for the
operation of this machine have
been completed at the factory.
Due to normal wear and use, some
occasional readjustments may be
necessary.
● CAUTION-Use of controls or
adjustments or performance of
procedures other than those
specified herein may result in
hazardous radiation exposure.
● CAUTION-The use of optical
instruments with this product will
increase eye hazard.
● Do not attempt to repair or
disassemble the laser. If unqualified
persons attempt to repair this laser
product, serious injury may result.
Any repair required on this laser
product should be performed by
authorized service center personnel.
WARNING
!
4
3
2