Craftsman 137.21807 - Manual (Page 3)

2 3 2 3
PRODUCT SPECIFICATIONS
MOTOR
Type............................................................................. Universal
Amperes....................................................................... 15 Amp
Voltage........................................................................ 120V AC
Hz................................................................................ 60Hz
RPM (no load) ............................................................ 5000 RPM (No load)
Overload Protection....................................................
Yes
BLADE SIZE
Diameter...................................................................... 10 in.
Arbor size.................................................................... 5/8 in.
SAW
Rip fence...................................................................... Yes
Miter gauge.................................................................. Yes
Rip Capacity ................................................................ 24 in. Right & Left
Maximum Cut Depth @ 90º ......................................... 3 in.
Maximum Cut Depth @ 45º ......................................... 2-1/2 in.
Maximum Diameter Dado ............................................ 6 in. (Stackable only)
Maximum Dado Cut Width ........................................... 1/2 in.
WARNING
!
To avoid electrical hazards, fire hazards or damage to the tool, use proper
circuit protection.
This tool is wired at the factory for 110-120 Volt operation. It must be
connected to a 110-120 Volt / 15 Ampere time delay fuse or circuit breaker.
To avoid shock or fire, replace power cord immediately if it is worn, cut or
damaged in any way.
Before using your tool, it is critical that you read and understand these
safety rules. Failure to follow these rules could result in serious injury to
you or damage to the tool.