Dmx terminator, Common dmx - dmx, 1 description of the side panel – OmniSistem WiDMX Transceiver User Manual
Page 8: 2 making a dmx 512 signal cable, Xlr 5-pin, Xlr 3-pin
1
5
3
4
2
1
5
3
4
2
2.1
DESCRIPTION OF THE SIDE PANEL
1
Standard DMX 512 signal OUTPUT with a 3/5-pole cannon connector.
2
Standard DMX 512 signal INPUT with a 3/5-pole cannon connector.
3
DMX TERMINATOR
1
2
3
2.2
MAKING A DMX 512 SIGNAL CABLE
Wi DMX has a DMX 512 input/output that uses standard XLR 5-pin or XLR 3-pin
connectors.
The connection must be put into practice with shielded cable by these characteristics:
- 2 conductors + shield
- 120 Ohm impedance
- low capacity
- maximum transmission rate 250 Kbaud.
For the connection refer to the underlying picture
ATTENTION: the shield of the cable must never be connected to the ground of the
electrical system as this could cause faults during the working of the Wi DMX.
1
5
3
4
2
Common
DMX -
DMX +
XLR 5-pin
1
3
2
Common
DMX -
DMX +
XLR 3-pin