Chamberlain RWA300R - Manual (Page 3)

3
Mount PIR Motion Sensor
horizontally on solid surface a few
feet off the ground and within 900'
of Base Station (rotate sensor to
access screw holes). Unit should be
able to swivel as needed. Attach sun/rain shield.
NOTE: Keep PIR Motion Sensor antenna away from
metal objects. Do not mount PIR Motion Sensor in
direct sunlight, near moving tree branches, or in the
path of a sprinkler system.
PIR Motion Sensor Installation
3' - 5'
10' - 20'
-
-
ACCESSORY
N/O (Normally Open)
COM (Common)
The Base Station has a relay which can activate other
devices such as a low voltage doorbell, buzzer or
light. The accessory device will need a separate
power supply. The accessories can be purchased at
any electronics store.
NOTE: Output switching capacity is low voltage
(max 24V dc or ac).
Advanced Features
Vehicle Alert Installation: For cars, the best
mounting position is about 4' high, between 10-20'
back, and angled to see the back of car after passing
the sensor.
Step 7
Step 5
Plug in Base Station. Adhere
rubber pads to bottom. A
9-Volt battery (not provided) is
optional in case of power
failures.
OPTIONAL
A
B
Programming PIR Motion
Sensor to Base Station
B Within 5 seconds, wave hand in front of PIR Motion
Sensor. Test light will illuminate and Base Station
will buzz.
A
B
A Ensure Base
Station and PIR
Motion Sensor are
in close proximity
to each other.
Press and release
learn button on
Base Station.
Buzzer will sound.
Step 6