beautypg.com

Additional aux module – Compex Systems Professional Portable Mixing Console SONOSAX SX-S User Manual

Page 19

background image

9.

ADDITIONAL AUX MODULE

The Aux Module provides 2 additional Auxiliary Outputs available on two Bantam Jacks on the rear of the mixer.

9.1 AUX Send potentiometers

The signal of each of the Inputs can be directed to the 2 Auxiliary Outputs through the potentiometer pairs marked
1 through 8.

9.2 External Input

If fitted the signal from one external source can be applied to the auxiliary Outputs through the potentiometer pair

marked ext.

9.3 Aux Master control

The potentiometers marked Masters control the final level of the mixed signals to each of the Auxiliary Outputs.

9.4 Talkback Microphone

If fitted, a 3-pin XLR on the rear panel of the mixer can direct the signal from a microphone through either or both
of the pushbuttons to their respective Aux Output. This provides a simple means of slating to an Aux bus. A limiter

circuit prevents overload from the Tbk mic.

9.5 Installation

Attach the necessary XLR and Bantam Jacks to the mixer's rear panel and fit the module into its slot. The module
requires 2 connections to the mix bus ribbon cable. (An additional 26-pin connector must be installed on the mix

bus ribbon cable).

A ribbon connector is provided with connectors to attach to J-5 of each Input module. The signal is taken before
the Fader of the Input modules.

Click here for Drawing of AUX Module Connections

{

J-3 (on both boards) Auxiliary output that connects to the Bantam Jacks

{

J-4 connects to the Tkb mic XLR connector

{

J-5 connects to the external Input XLR connector

{

P-11 (on both boards) controls output symmetry, is factory adjusted and should not be touched.

{

P-12 is the Level control for the Tbk mic.

Seite 19 von 22

SONOSAX SX/S USER MANUAL

26.08.2004

file://D:\Z_Library\Webcopy\sonosax\SXS\sxsume.html

This manual is related to the following products: