O.S. Engines FS-200S-P - Manual (Page 5)

8
Make sure that the tank is well rinsed out with methanol or
glow fuel before installation and that the pickup weight is
well clear of the bottom of the tank when held vertically. For plumbing, use heavy duty silicone tubing of 2.5mm
inner dia and 5mm outer dia.
The suggested fuel tank size is 500cc or 14 oz. This will
give approximately 12-13 minutes running time when some
part-throttle operation is included.
Approx. 15mm
It is suggested to keep the distance between the carburetor and
fuel tank within 500~600mm.
Vent
FUEL TANK & LINES
9
INSTALLATION
Because the FS-200S-P is a powerful, large-displacement, single-cylinder four-stroke-cycle engine, it is essential to use very
substantial engine mounting. Conventional wooden mounting beams should be of rigid hardwood and of at least 15mm or 5/8-
in square section.
CORRECT
Top surfaces are in the same plane.
INCORRECT
Front view Side view
Re-align the surfaces
as necessary
Opposite beam
Top surfaces are not in the
same plane.
Engine does not rest firmly.
Top surfaces are not
in the same plane.
Make sure that the mounting beams are parallel and that their top surfaces are in the same plane.