NORAC UC4.5-BC Quick Guide - Manual (Page 14)

11
 To exit the install now before changing any settings press the button.
 The control panel is loading all the settings for the sprayer.
Wiring Test:
 Use the sprayer's manual controls to move the left boom up.
 If the wrong boom moves or if the direction is incorrect, stop the setup. Consult the
UC4.5 Installation Manual to check the hydraulic plumbing and electrical wiring of the
system.
 The control panel confirms the wiring is correct. Continue the process with the remaining
booms.
Note: Some sprayer types do not support a wiring test or they may support a different style of test. If
there are no messages displayed in this step, simply continue as prompted by the panel.
Sensor Detect:
 Position all boom sections such that the nozzles are 35 inches (90 cm) from the ground.
 Press
to continue.
Note: If it is not possible to get all the booms set to exactly 35 inches (90 cm), the sensor height can be
adjusted after the install is finished.
 Hold the button to begin the sensor detect sequence. The button must be held for
the duration of the procedure. If is released, simply press and hold again to continue
the procedure.
Proceed?
Hold Auto Until
“Done”
Height
35 inch Booms at Level
Left Up
Dfalting
Press
Left Ok