NORAC 5468BC - Manual (Page 8)

5
5 Electrical Installation
1. Remove the existing cable C03 from the existing input module (E03).
2. Connect one end of cable C03 to the existing input module (E03) and the other end to the
3-way coupler (E10).
3. Connect existing cable C03 to the third connector on the 3-way coupler (E10).
4. Connect one end of cable C04 to the 2-way coupler (E12) and the other end to the 3-way
coupler (E10).
5. Connect the cable from the Roll Sensor (E04) to the other end of the 2-way coupler (E12).
6. Secure all cables with the ties provided.
Figure 2: Electrical Connections
Only components shown in black are included with this kit.