beautypg.com

NORAC 5467BC-JD User Manual

Page 10

background image



7

10. Deburr the holes. Install the mounting bolts into the holes and snug. Drill the second set of

holes and install the mounting bolts. Torque the bolts to 20 ft-lbs (27 Nm).

Figure 12: Upper Pin Installed

11. In some cases, the bracket has failed at the weld shown in Figure 13. It is recommended

that all sprayers with roll control add weld to the existing bracket to prevent failure. Some
sprayers from 2005 and newer already have gussets added at the factory.

Figure 13: Roll Cylinder Mount Weld Locations

12. Connect the hoses and fittings to the cylinder ports. The hose with the 90 fitting goes to

the cap end of the cylinder.

13. Connect the cylinder cable to the 8-way coupler using the 2-way coupler (E12) and cable

C04.

Figure 14: Roll Cylinder Installed with Hoses