NORAC 5467BC-4B - Manual (Page 22)

19
6 Electrical Installation
1. Locate the valve module installed on the NORAC valve block. Remove the plugs installed
in positions 7 and 8.
2. Connect the 2 pin connector on cables C10 into positions 7 and 8 on the valve module.
Connect the other end of cables C10 to the 2 pin connectors on the NORAC expansion
block (V70).
3. If installing this kit on a sprayer that has an existing passive roll control system, disconnect
and remove the two NORAC roll sensors (small rectangular box with a cable running from
it). See for Figure 20 locations.
Figure 20: Roll Sensor Locations (Viewed from the rear of sprayer)
4. Connect the position sensor (E06) and the active roll cylinder (H75) to the 8-way coupler
(E11) using cable C04 and a 2-way coupler (E12).
Figure 21: Valve Module Connections
Output Number Normal Function
1 Left Up
2 Left Down
3 Right Up
4 Right Down
5 Option 1
6 Option 2
7 Roll CW
8 Roll CCW